Table of Contents
Advertisement
2.9 Making SFP Fiber Connection
The SFP slot must be installed with an SFP fiber transceiver for making fiber connection.
Type of the SFP Fiber transceivers supported:
100Mbps based 100BASE-FX SFP transceivers
Installing SFP Fiber Transceiver
T o install an SFP fiber transceiver into SFP slot, the steps are:
2 1 7 B
1. Turn off the power to the device.
2. Insert the SFP fiber transceiver into the SFP slot. Normally, a bail is provided for every SFP
transceiver. Hold the bail and make insertion.
3. Until the SFP transceiver is seated securely in the slot, place the bail in lock position.
Connecting Fiber Cables
LC connectors are commonly equipped on most SFP transceivers. Identify TX and RX connector
before making cable connection. Make sure the Rx-to-Tx connection rule is followed on the both ends
of the fiber cable.
Network Cables
Multimode (MMF) - 50/125, 62.5/125
Single mode (SMF) - 9/125
Port Configuration
100Mbps
Full duplex
No auto-negotiation
-26-
Advertisement
Table of Contents
