Sfp Configuration Dip Switch (Sw4); Led Indication - KTI Networks KGC-301 Installation Manual

2.6.1 SFP Configuration DIP Switch (SW4)

SW4 Mode
OFF 1000Mbps, Full duplex, Auto-negotiation enabled (Factory default)
ON Auto detection
Full duplex Line rate, 1000Mbps or 100Mbps is determined by detecting the data
rate information embedded in the installed SFP transceiver
Note: The setting change of SW4 takes effect after next device power-up.

2.7 LED Indication

LED State
PWR ON
TP-LINK OFF
ON
TP-1G OFF
ON
FX-LINK OFF
ON
FX-1G OFF
ON
MCU ON
Blink
Interpretation
The device is powered on.
The UTP port is link down.
The UTP port is link up.
The UTP port line rate is 10 or 100Mbps.
The UTP port line rate is 1000Mbps.
The SFP port is link down.
The SFP port is link up.
The SFP port line rate is 100Mbps.
The SFP port line rate is 1000Mbps.
No diagnostic error detected
Diagnostic error detected
15