Configuring Ip Address & Password; Ip Address & Password; Configuring Ip Address & Password Via Console; Configuring Ip Address Via Web Interface - KTI Networks KSC-361 User Manual

4. Configuring IP Address & Password
The converter supports the following methods to configure the device as follows:

Use CLI via the console mode of the serial port (SW [CM] setting ON)

Use web interface over TCP/IP network via LAN port
4.1 IP Address & Password
The IP Address is an identification of the device in a TCP/IP network. Each device should be designated a new
and unique IP address in the network. The converter is shipped with the following factory default settings for
software management:
IP address of the switch: 192.168.0.2 / 255.255.255.0
Default
Default password: 123
The converter uses local authentication with factory defaults.
The password is required for local authentication in accessing to the device via Http web-based interface. For
security reason, it is recommended to change the default settings for the device before deploying it to your
network.
4.2 Configuring IP Address & Password via console
Setting SW [CM] ON will set the Serial Port to Console Mode for configuration.
The configuration commands are:
at+set sys name=?
at+set sys password=?
at+set sys ip address=?
at+set sys subnet mask=?
at+set sys gateway=?
at+set sys dns server=?
Refer to "Operation manual for telnet and console management".

4.3 Configuring IP Address via Web Interface

Start Web Browser
Start your browser software and enter the default IP address of the switch unit to which you want to connect.
The IP address is used as URL for the browser software to search the device.
-36-