Troubleshooting - Fisher & Paykel WD8560F1 Installation Instructions And User Manual

The following is a list of problems you may encounter when using this appliance and
some suggestions that may help to correct the problem. If you still have problems,
please contact your Fisher & Paykel trained and supported service technician.
Solving general operating problems
PROBLEM
Washer dryer not
turning on.
Touching does
not start filling or
drying.
Washer dryer is
paused.

TROUBLESHOOTING

POSSIBLE CAUSES
Electrical cord not plugged
into a power socket.
Power not switched on at
the wall.
Household power supply
not working.
'Keylock' may be
activated.
Washer dryer door not
closed properly.
The washer dryer has
detected a fault.
Cold tap turned off.
Blocked hose filter.
Inlet hose leaking, twisted
or damaged.
Faulty water supply.
'Delay Start' may be set.
light is flashing.
WHAT TO DO
Plug cord into a power socket.
Switch the power on at the wall. Then
touch 'POWER'.
Try plugging another electrical
appliance into the same socket. Turn
off the power at the power point.
Unplug the washer dryer from the
power socket. Wait 60 seconds, plug
it back in, turn it on and try again.
Touch and hold the 'POWER' button
for 2 seconds. Refer to page 37.
Open and reclose door.
Check if a code is being displayed on
the panel. (Refer to pages 40 – 42).
Check that the cold tap is turned on.
Check the tap end of the inlet hose
for blockages.
Check the inlet hose for leaks or
damage. Check that the inlet hose is
not twisted.
Check the cold tap is connected to
the machine and is working.
Refer to page 35.
Touch the button to resume the
cycle.
43