Fisher & Paykel WD8560F1 Installation Instructions And User Manual page 43

Front loading washer dryer
Hide thumbs Also See for WD8560F1:
Table of Contents

Advertisement

PROBLEM
DISPLAYED AS
Machine is
too hot.
Door is
locked.
Door is open.
The pump
filter is
blocked.
Machine is
cooling down.
Once you have addressed the user warning try using your washer dryer as per usual.
If the symptom persists, call your Fisher & Paykel trained and supported service
technician.
BEFORE YOU CALL FOR SERVICE
WHAT TO DO
The temperature in the drum is over 60°C therefore it
is not safe to open the door. Wait until the temperature
drops below 60°C then the machine will open the door.
The temperature in the drum is over 60°C therefore
it is not safe to open the door. Wait until the
temperature drops below 60°C.
Check the water level in the drum. If the level is above
the bottom of the door seal, the door cannot be
opened. Use the 'Add a Garment' button if you wish
to add or remove items.
If the drum is still moving, wait for it to stop before
attempting to open the door.
Close the door fully and touch
Try opening and closing the door again.
Reposition the load, make sure the load is correctly in
the drum and that protruding items are not stopping
the door from closing.
Machine will stop and flash
is not draining out of the drum. This can be caused
by foreign objects or a build up of lint in the pump or
filter. Clean the filter, refer to 'Caring for your washer
dryer' on how to remove the filter (if the machine is in
the middle of a cycle and has a drum fill of water a lot
of water might come out).
Run a 'Drum Clean' cycle to flush out any residue or
lint that may be caught in the machine after cleaning
out the filter. If this happens often, clean the filter out
regularly.
The machine is performing a cool down to reduce the
temperature inside the drum so it is safe to open. This
time can vary depending on a number of factors. Let
the machine perform this cool down period so it is
safe to access items of clothing.
if the 'Add a garment' button is selected and if
pushed.
will be displayed at the end of a drying cycle,
.
if the water
is
41

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd7560p1Wd8060p1

Table of Contents