Please read and follow the 'Safety and warnings' and 'Installation instructions'
sections carefully before using your washer dryer!
Accessories
Please check you received the following accessories with your Fisher & Paykel washer
dryer. You will find them inside the drum:
1 x Inlet hose
●
●
1 x Drain hose guide
●
●
1 x Installation instructions and user guide
●
●
1 x Spanner
●
●
1 x Installation leaflet (attached to the top of the washer)
●
●
1 x Hose clamp (WD8060P1 model only)
●
●
Unpacking
To ensure the best performance from your new washer dryer please follow the
instructions below.
Removing the packaging
Remove the outer packaging (including the polystyrene packer and plastic wrapping).
1
All packaging must be removed prior to use. Ensure these materials are kept out of
reach of children. Note: a small amount of water may be seen inside the packaging and
inside the washer dryer. This is the result of factory testing and is normal.
Tilt the product backwards and 'walk' it off the base one foot at a time. Not doing so
2
may cause damage to your floor and washer dryer.
Remove all packaging and accessories from inside the drum.
3
Removing the transit bolts
The clothes washer dryer is fitted with 4 transit bolts at the rear to prevent internal
damage during transportation.
IMPORTANT!
The 4 transit bolts MUST be removed prior to operation of the machine. Failure to
●
●
remove these will result in damage to the product.
Ensure packaging materials are kept out of reach of children.
●
●
Please help protect the environment and dispose of the packaging from around the
●
●
washer dryer in an environmentally friendly manner.
INSTALLATION INSTRUCTIONS
9