Connecting to the water supply
Inlet hose
IMPORTANT!
A new hose is provided with the washer dryer and
●
●
should be used to connect the washer dryer to the
water mains.
Old hoses should not be re-used.
●
●
We recommend that the inlet hose be changed every
●
●
5 years. WARNING: Failure to do so may result in a
flood and damage to property.
Connect the straight end of the inlet hose to the cold tap and the elbow end to the
1
machine inlet valve. Tighten the inlet hose end by hand until the hose seal just makes
contact with the tap sealing face and then tighten a further half-turn. Make sure there
are no kinks in the hose.
Turn the tap on and check for leaks. Check for leaks again after 24 hours.
2
IMPORTANT!
The cold water temperature should not exceed 35°C.
Water supply requirements:
Inlet water pressure: Maximum 1000kPa (150psi), Minimum 30kPa (4.5psi)
●
●
Inlet water flow rate: Minimum 6 litres/minute
●
●
Note: an internal heater in the product will heat the cold water to the selected cycle
temperature.
INSTALLATION INSTRUCTIONS
Straight
Elbow
(tap) end
(machine) end
Inlet hose ends
13