Fisher & Paykel WD8560F1 Installation Instructions And User Manual page 41

Cleaning the hose
The hose has a filter in it, preventing any solid contaminants in the water entering your
washer dryer. Occasionally you should disconnect the water inlet hose where it connects
to the taps, check for any build up of dirt and wash this out.
Nappy sanitisers/bleach
Nappy sanitisers and bleach are very corrosive to metal surfaces. DO NOT tip the
contents of a nappy bucket into your machine. Rinse and wring items out thoroughly
before placing them in the machine.
Moving your washer dryer
If you need to move your washer dryer a considerable distance (eg moving house),
remember to replace the transit bolts before moving it. These will protect internal
components of the washer dryer from damage.
To replace the transit bolts, pull out the bolt-hole covers at the back of the machine.
Push the transit bolt rubber grommets and plastic spaces into the hole left and tighten
it with the spanner provided with the product.
Make sure any water in the washer dryer is drained out. This can be done by cleaning
out the pump filter (refer to 'Caring for your washer dryer' section 'Cleaning the pump
filter').
IMPORTANT!
Leave the door to your washer dryer open when it is not in use to allow the washer
● ●
dryer to dry out, otherwise it will develop unpleasant odours. When leaving the door
open like this, it is extremely important that children and pets are kept away from the
washer dryer so they cannot be accidentally trapped inside it.
Aside from the detergent dispenser, water hose, and the pump filter, no other parts
● ●
are designed to be removed from the machine for cleaning. Do not attempt to remove
any other part of the machine.
CARING FOR YOUR WASHER DRYER
39