General Troubleshooting - Fisher & Paykel 11 Series User Manual

PROBLEM
Display will not
turn on
Display not
responding
Washer/Dryer
will not start
Appliance is
beeping and
displaying
a code
46

GENERAL TROUBLESHOOTING

POSSIBLE CAUSES
No power.
Appliances need to be reset.
Software update may be
required.
The controls are locked.
Door not closed properly.
A fault has been detected.
is set.
DELAYED START
A fault has been detected.
WHAT TO DO
Ensure the appliances are plugged in
and the power supply is turned on at
the wall.
Press the dial to turn the appliances off.
Wait a few seconds, then press the dial
again to turn the appliances back on.
If the problem persists, try turning the
appliances off and on again at the wall.
The display may take a few seconds to
load.
If the appliances are connected
to Wi-Fi, check if any updates are
available.
Press and hold the screen to unlock
the controls.
Open and re-close door.
Check if a code is being displayed
on the control panel. Refer to
'Fault codes'.
Refer to 'Wash cycle options' or 'Dry
cycle options'.
Check if a code is being displayed
on the control panel. Refer to
'Fault codes'.