Table of Contents
Advertisement
EASY TO INSTALL
Wilson Electronics designs and manufactures a full range of wireless
amplifi ers for in-building applications.
The following steps provide a summary of the amplifi er/antenna installation
process. However, they are not a substitute for the complete installation
instructions on the following pages, which you should read thoroughly. Contact
Wilson's Technical Support Department with any questions at 866-294-1660.
1 Select a location to install the amplifi er that is away from excessive heat, direct
sunlight and moisture.
2 Select a location on the roof of the building to install the outside antenna. Use
a cell phone in test mode to fi nd the strongest signal from the cell tower. Visit
wilsonelectronics.com to fi nd test mode function for your particular cell phone.
3 Select a location for the inside antenna, preferably in the center of where the
signal needs to be amplifi ed.
4 Verify that both the outside antenna and the inside antenna are connected
before powering up the amplifi er.
Lightning protection is recommended for all in-building installations.
Typical Installation
3
DT Wireless
1
Amplifer
Power
Supply
Warning: See RF safety
warning on page 6.
Inside Antenna
3
2
Hide quick links:
Advertisement
Table of Contents
