Table of Contents
Advertisement
Setup Program
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Calibrate the hoop».
– The machine recognizes the embroidery hoop automatically.
> Touch the icon «Delete» (1) to delete the present calibration.
> Center the needle via the arrow icons on the display.
1
> Touch the icon «Confirm» to save the calibration.
Entering the fabric thickness
If the fabric thickness is more than 4 mm as for e.g. toweling, it is recommended to select 7.5 mm or
10 mm. The thicker the fabric, the slower the embroidery speed of the machine. When the machine is
switched off, the alterations are reset to the default setting 4 mm.
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Select the fabric thickness».
> Select fabric thickness.
Function thread removal on/off
To bring up the thread end after cutting and to pull it out of the fabric, the function must be activated. As
for embroidery motifs with long stitches it is recommended to deactivate the function thread removal.
> Touch the icon «Setup Program».
> Touch the icon «Thread removal».
> Touch the switch using the touchscreen pen/finger to activate the function thread removal.
> Touch the switch using the touchscreen pen/finger again to deactivate the function thread removal.
62
Advertisement
Table of Contents
