Start-up
Confirm settings.
If the function block is not closed, further function block parameters can be adjusted.
Proceed as follows:
1. Open data point.
2. Make desired changes and confirm.
3. If applicable, the next function block parameter is displayed.
When all function block parameters have been adjusted, select End and confirm.
The active function block is closed.
An active function block is represented by a black square on the right-hand side below
the function block number.
To adjust additional function blocks, repeat the steps in the fields highlighted in gray.
q
Select End .
Exit configuration level.
Return rotary switch "Configuration and parameterization" to INFO. Display shows: time
20
EB 5433 EN