Draytek VigorAP 902 User Manual page 91

Antenna
Tx Power
Rate Adaptation
Algorithm
Fragment Length
RTS Threshold
Country Code
Auto Channel
Filtered Out List
MAC Clone
VigorAP can be attached with two antennas to have good data
transmission via wireless connection. However, if you have
only one antenna attached, please choose 1T1R.
The default setting is the maximum (100%). Lowering down
the value may degrade range and throughput of wireless.
Wireless transmission rate is adapted dynamically. Usually,
performance of "new" algorithm is better than "old".
Set the Fragment threshold of wireless radio. Do not modify
default value if you don't know what it is, default value is 2346.
Minimize the collision (unit is bytes) between hidden stations
to improve wireless performance.
Set the RTS threshold of wireless radio. Do not modify default
value if you don't know what it is, default value is 2347.
VigorAP broadcasts country codes by following the 802.11d
standard. However, some wireless stations will detect / scan
the country code to prevent conflict occurred. If conflict is
detected, wireless station will be warned and is unable to make
network connection. Therefore, changing the country code to
ensure successful network connection will be necessary for
some clients.
The selected wireless channels will be discarded if AutoSelect
is selected as Channel selection mode in Wireless
LAN>>General Setup.
Click Enable and manually enter the MAC address of the
device with SSID 1. The MAC address of other SSIDs will
change based on this MAC address.
81
VigorAP 902 User's Guide