Advanced Setting - Draytek VigorAP 902 User Manual

3 . 7 . 2 A d v a n c
3 . 7 . 2 A d v a n c
This page is to determine which algorithm will be selected for wireless transmission rate.
Available settings are explained as follows:
Item
Channel Width
Packet-OVERDRIVE This feature can enhance the performance in data transmission
VigorAP 902 User's Guide
e d S e t t i n g
e d S e t t i n g
Description
20 MHz - AP will use 20MHz for data transmission and
receiving between the AP and the stations.
Auto 20/40 MHz - AP will use 20MHz or 40MHz for data
transmission and receiving according to the station capability.
Such channel can increase the performance for data
transmission.
40 MHz - AP will use 40MHz for data transmission and
receiving between the AP and the stations.
about 40%* more (by checking Tx Burst). It is active only
when both sides of Access Point and Station (in wireless
client) invoke this function at the same time. That is, the
wireless client must support this feature and invoke the
function, too.
Note: Vigor N61 wireless adapter supports this function.
Therefore, you can use and install it into your PC for matching
with Packet-OVERDRIVE (refer to the following picture of
Vigor N61 wireless utility window, choose Enable for
TxBURST on the tab of Option).
80