Samson 3730-2 Mounting And Operating Instructions page 7

The fault alarm contact is triggered by the condensed status of the positioner.
It is always active with "Maintenance alarm" condensed status.
If Code 32 is set to Yes : Also active with "Function check" condensed status
If Code 33 is set to Yes : Also active with "Maintenance required/Mainte-
nance demanded" condensed status
The "Function check" condensed status is additionally set for Test A1, A2,
fault alarm output and position transmitter.
The min./max. values of the temperature monitoring can be reset.
The fault alarm contact is triggered by the condensed status of the positioner.
It is always active with "Maintenance alarm" condensed status.
If Code 32 is set to Yes : Also active with "Function check" condensed status
If Code 33 is set to Yes : Also active with "Maintenance required/Mainte-
nance demanded" condensed status
The "Function check" condensed status is additionally set for Test A1, A2,
fault alarm output and position transmitter.
The min./max. values of the temperature monitoring can be reset.
Note!
These Mounting and Operating Instructions EB 8384-2 EN are valid for positioners with firm-
ware versions 1.40 to 1.49.
The latest edition of these instructions, detailing the firmware version and modifications com-
pared to the previous version, are available on the Internet at http://www.samson.de.
Firmware modifications
EB 8384-2 EN
7