Samson 3730-2 Mounting And Operating Instructions page 65

Setting the switching point:
Note!
During adjustment or testing, the switching
point must always be approached from
mid-position (50 %).
To ensure safe switching under any ambient
conditions, the switching point is to be ad-
justed to a value of approx. 5 % before the
mechanical stop (OPEN – CLOSED).
For CLOSED position:
1. Initialize positioner.
2. Use the MAN function to move the
positioner to 5 % (see LCD).
3. Adjust the tag using the yellow adjust-
ment screw (2) until the tag enters or
leaves the field and the switching ampli-
fier responds. You can measure the
switching voltage as an indicator.
Contact function:
Tag leaving the field > contact is made.
Tag entering the field > contact is opened
For OPEN position:
1. Initialize positioner.
2. Use the MAN function to move the
positioner to 95 % (see LCD).
3. Adjust the tag (1) using the yellow ad-
justment screw (2) until the tag enters or
leaves the field of the proximity
switch (3).
You can measure the switching voltage
as an indicator.
Contact function:
Tag leaving the field > Contact is made.
Tag entering the field > Contact is opened
Adjusting the limit switch
EB 8384-2 EN
65