Cable Routing; Test Printing - CognitiveTPG A776II User Manual

14
Chapter 3: Settng up the Printer

Cable routing

Prevent the printer from being accidentally unplugged by making sure the cables are routed as shown in the
illustration below.

Test printing

This test prints a complete list of printer settings (Diagnostic form) and partially cuts the paper (see sample on next
page). The test items listed may vary depending on the printer model. This printout is useful to a service representative
when there is a problem. If the quality of the test printout is poor (missing or faded text) see the Troubleshooting
section on page 29.
Instructions at the end of the test printout describe how to enter the configuration menu. The configuration menu
allows you to change the current settings of the printer.
Test Procedure
1. To run the test, open the receipt cover (1); then,
while holding down the paper feed button, close
the receipt cover (2).
2. When the printer begins printing let go of the paper
feed button. The diagnostic printout will print.
3. Review this printout for printer settings. If you wish
to change any of these settings go to the
configuration menu as instructed at the bottom of
the printout.
4. Make selections as instructed on the printout.
A776II Two-Color Thermal/Impact Hybrid Printer: User Guide
Open
1
receipt
cover
A776 Test Printer.eps
CAUTION
Be careful when you change any of the printer settings
to avoid entering any changes that you don't intend to
make.
Push and hold
2
paper feed button
while closing
receipt cover
A776 2UG0001 B 11/2016