Table of Contents
Advertisement
16
Chapter 3: Settng up the Printer
Printer configurations
Printers are shipped with all the functions and parameters pre-set at the factory, but you can change these settings
manually. The instructions for accessing the menu appear on the bottom of the test printout receipt.
CAUTION
Be extremely careful changing any of the printer settings to avoid possibility of changing other settings that might
affect the performance of the printer.
The following functions and parameters can be changed in the scrolling configuration menu, except for those marked
with an asterisk (*):
•
Communication Interface
RS-232C serial interface
Universal serial bus (USB)
Ethernet* (cannot be set -see next page 13)
RS-232C serial interface settings
Baud rate
Data bits* (fixed at 8)
Stop bits* (fixed at 1)
Parity
Flow control
Hardware (DTR/DSR) or
Software (XON/XOFF)
Data reception errors
Alternate DTR/DSR
•
Diagnostic Modes
Normal
Datascope
Receipt test
Slip test
MICR test
Check flip test
A776II Two-Color Thermal/Impact Hybrid Printer: User Guide
•
Emulation/software options
Printer emulations
A776II native
A756 emulation
Printer ID
Receipt Options
Default lines per inch
Carriage return usage
Default font
Font size
Slip options
•
Hardware options
Print head setting
Paper type
Color density
Print density (mono)
Alternate reset feature
Paper low sensor
MICR
MICR dual pass option
•
Paper Type
•
Firmware Features
Paper selection lockout
Beep after knife cut
Cash Drawer open after knife cut
A776 2UG0001 B 11/2016
Advertisement
Table of Contents
