Centralized Operator Setup - Samsung Officeserv 7100 Technical Manual

OfficeServ 7100
TECHNICAL MANUAL
the audio prompts and dialing digits as the interactive soft keys will not be shown at the
remote location, unless all nodes are running 2.3x software or higher.
• In MMC 825 set the "USE REMOTE VM" option to YES
• In MMC 825 program the station group for the SVM in the main location under
"REMOTE VM NUMBER" e.g. 50-49
• Confirm that at the main location that the entries in MMC 824 that require voice mail
boxes have the MB: option set to Y so that when a VM download is performed these
mailboxes and extension id's will be automatically created.
• Make sure you have created mailboxes for the remote node stations on the SVMi
using MMC 740 (or SVMi Mailbox Administration). Create these mailboxes on the
system where the SVMi resides.

Centralized Operator Setup

This setup allows all dial "0" calls in the remote system to call the operator in the main
system. This feature only works with dial "0" calls. This is accomplished by changing
the attendant destination in MMC 825.
DID Pass Through
This will allow DID calls that come in on circuits on the main location to ring at the
remote locations.
• In MMC 724 under NTWK LCR NUMPLAN make an entry for an unused station
number block for example 30:
[NTWK LCR NUMPLAN]
[LCR-05:NONE→30 ]
• In MMC 824 for entry "30" fill out the display to route the calls to switch 002
indicating the total number of DID digits plus the 3 digit access code as the MAX
entry as follows:
[05:30 →002
[SZ:2 MAX:07 MB:N]
• In MMC 714 tell the incoming DID digits to "ring" 30 for all ring plans
• Translate the digits on the receiving side in MMC 714 as normal
NOTE: Repeat steps 1 through 4 for each remote switch using a different NTWK access
code for each switch.
]
2.8.9
Table of Contents
Home Page
SPECIAL APPLICATIONS
PART 2 JANUARY 2009