Samsung Officeserv 7100 Technical Manual page 69

OfficeServ 7100
TECHNICAL MANUAL
to the ring mode 1~6. B means a station, station group, trunk or trunk group
which is the same number with the received one.
• CW
: For Call Waiting. This is not used for networking.
• DELETE: The number of digits to delete.
• NAME: The name of the DID table.
e.g. for switch 001:
Digits Destination
20** RP1~RP6 = B
21** RP1~RP6 = B
22** RP1~RP6 = 22
23** RP1~RP6 = 23
50** RP1~RP6 = B
51** RP1~RP6 = 51
52** RP1~RP6 = 52
561 RP1~RP6 = 9
When the 10 steps described above have been completed intercom networking is
completed.
Centralized Voice Mail Setup
NOTES
1. The OfficeServ 7100 does not support the SVMi-20E card. However, the
OfficeServ 7100 can be a remote system that used the Centralized Voicemail off
of another node. All references to SVMi and Centralized Voicemail in this
document refers to SVMi/Centralized Voicemail installed in other nodes such
that the OfficeServ 7100 is a remote node using the Centralized Voicemail
resources remotely via the SPNET.
2. It is recommended that the embedded OfficeServ 7100 Voicemail NOT be used
as the Centralized Voicemail.
This setup takes place at each of the remote locations and allows these locations to
use the SVM system in the central location. When messages are left at the central
location the VMMSG key at the remote location will illuminate to indicate a message.
The "new message" counter will not be shown in the keyset displays at the remote
location, unless all nodes are running 2.3x software or higher. When the message is
returned to the SVM by pressing the VMMSG all navigation must be done by following
Delete Reason
0 Intercom Calls to
0 Switch 001
2 ICM to 002 from 003
2 ICM to 003 from 002
0 Intercom to 001 groups
2 Calls to 002 groups
2 Calls to 003 groups
1 tandem local calls
2.8.8
Table of Contents
Home Page
SPECIAL APPLICATIONS
PART 2 JANUARY 2009