Mgi Programming Mmcs - Samsung Officeserv 7100 Technical Manual

Table of Contents
Home Page
OfficeServ 7100 SPECIAL APPLICATIONS
TECHNICAL MANUAL PART 2 JANUARY 2009

MGI Programming MMCs

There are 14 MMCs directly related to the use and operation of the MGI card.
MMC 615 MGI GROUP
Assigns permissions of use for individual MGI ports. Separates range of ports to be
allowed for MGI Services
MMC 616 MGI USER
Assigns permissions of use for individual MGI ports. Separates individual ports to be
allowed for MGI use. Allow specific stations or trunks to only use the specified MGI
port.
MMC 830 ETHERNET PARAMETERS
Assigns MP10/MP10a system IP address, subnet, gateway and MP10/MP10a Public
address (if required).
MMC 831 MGI PARAMETERS
Assigns MGI IP address(es), subnet, gateway and Public address (if required).
MMC 832 VoIP OUT DIGITS
Assigns VoIP access codes, access code length, the number of digits to delete or
insert, remote end trunk access code and IP selection tables
MMC 833 VoIP IP ADDRESS
Allows assignment of IP addresses in specific tables to route calls to remote
destinations
MMC 834 H.323 OPTIONS
This MMC programs incoming call destination type, CLIP table, CID type, auto codec
negotiation, call set up and signaling types and other parameters associated with VoIP
signaling when using as a trunking gateway.
MMC 835 MGI DSP OPTIONS
Assigns the individual parameters associated with the VoIP DSP operation. Codec
type, filtering, input gain, voice volume and RTP (real time transport protocol)
parameters.
MMC 836 H.323 GATEKEEPER OPTIONS
This MMC allow the setup parameter to allow the MGI to operate with a network
supported by VoIP Gatekeeper(s).
2.6.28