Subroutine 40 - Axis_Ctl (Controlling The Spindle And Axes) - Siemens SINUMERIK 808D Operating Instructions Manual

Descriptions of the PLC subroutines

3.13 Subroutine 40 - AXIS_CTL (controlling the spindle and axes)

3.13 Subroutine 40 - AXIS_CTL (controlling the spindle and axes)
Purpose
Subroutine 40 is used to control the drive pulse enable (DB380xDBX4001.7) and controller
enable (DB380xDBX2.1), monitoring the hardware limits and the reference cam signals, and
controlling the enable signal for the spindle according to a spindle command (for example,
SPINDLE CW, SPINDLE CCW, Mo3, M04, SPOS, etc.). The motor brake is automatically
controlled by the SINAMICS V60 drives.
This subroutine provides two ways to realize the hardware limit control:
● PLC solution (MD14512 [18] bit 6 = 0)
● Hardware solution (MD14512 [18] bit 6 = 1)
Note
The connection between the terminal 65 of the SINAMICS V60 and the +24 V signal is
cut off automatically at any of the hardware limits or an EMERGENCY STOP.
42
Each feed axis has one (MD14512 [18] bit 7 = 1) or two (MD14512 [18] bit 7 = 0)
hardware limit switches. This subroutine activates the NCK hardware limit function via the
NCK interface DB380xDBX1000.0 or DB380xDBX1000.1 according to the configurations
of the hardware limit switches, and thus makes the NCK produce a feed stop signal to an
over-distance axis.
Furthermore, you can also connect the output OVlmt of this subroutine with the input
HWL_ON of subroutine 33 to activate the Emergency Stop automatically once the
hardware limit of any axis has been reached.
This solution is independent of the PLC and thus is much safer:
_OVLrel
KA1
_3LMTp
_2LMTp
_1LMTp
KA1
E_Key
Operating Instructions, 12/2012, 6FC5397-2EP10-0BA0
PLC Subroutines Manual