Table of Contents
Advertisement
fiber or copper connector based on link availability. If a fiber link cannot be established, the device selects the
copper media.
10-Gbps Ports
The NetIron CES 2048CX and the NetIron CES 2048FX comes with 10-Gigabit Ethernet ports installed. A 24 port
NetIron CES has a slot to accommodate a 10-Gigabit Ethernet module. If your device does not include a 10-GbE
module, you can optionally install one. See "Installing or Replacing a 10-Gigabit Ethernet Module" on page 6-5.
The 10-Gigabit Ethernet ports use 10-Gigabit Small Form Factor Pluggable (XFP) MSA-compliant transceivers.
LED
10-Gbps Port LEDs
Lnk
Act
Supported Optics
100/1000 Ethernet Ports
This Ethernet Interface module contains 20 physical ports, through which you can connect your NetIron CES 2000
Series router to other network devices at a speed of 100 Mbps or 1 GbE.
Into a physical port, you must insert a fiber-optic transceiver provided by Brocade. The SFP-compliant fiber-optic
modules provide an optical transceiver or physical medium-dependent (PMD) interface for fiber that can be used
with the LAN physical layer (PHY)
The following 100 Mbps and 1 GbE optical transceivers are available from Brocade:
Table 2.5: SFP-Compliant Transceivers for the 100/1000 Ethernet Interface Module
Part Number
E1MG-TX
E1MG-SX
E1MTG-SX
E1MG-SX2-1310
E1MG-LX
E1MG-LHA
March 2009
Table 2.4: LEDs for the NetIron CES 2000 Series Ports
Position
State
Top right for left-
On
most connector
Off
Top left for right-
most connector
Bottom right for
On or Blinking
left-most
connector
Off
Bottom left for
right-most
connector
Description
SFP Copper, RJ-45 connector
1000Base-SX SFP optic, multi-mode fiber, LC connector
1000Base-SX SFP optic, multi-mode fiber, MTRJ connector
1310 1000Base-SX SFP optic multi-mode fiber, LC connector and support for
distances up to 2km
1000Base-LX SFP optic, single-mode fiber, LC connector
1000Base-LHA SFP optic, single-mode fiber, LC connector
© 2009 Brocade Communications Systems, Inc.
Meaning
The port is connected.
No fiber port connection exists.
Traffic is being transmitted and received
on the fiber port.
No traffic is being transmitted on the fiber
port.
Product Overview
2 - 7
Advertisement
Table of Contents
