Microphone Board - HP Elite x2 1012 G2 Maintenance And Service Manual

Reverse this procedure to replace the webcam and the rear webcam.

Microphone board

Description
Microphone board
IMPORTANT:
replacement.
Before removing the webcam, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see
b. Back cover (see
c. Display panel (see
d. Battery (see
e. Hall sensor board (see
f. Kickstand hinges (see
g. Solid-state drive (see
h. WLAN module (see
Make special note of each screw and screw lock size and location during removal and
Back cover on page
Display panel on page
Battery on page
Hall sensor board on page
Kickstand hinges on page
Solid-state drive on page
WLAN module on page
Kickstand on page
29)
30)
32)
34)
35)
36)
38)
Spare part number
924449-001
26)
Component replacement procedures 43