Pogo Connector - HP Elite x2 1012 G2 Maintenance And Service Manual

CAUTION:
2. Remove the micro SD card tray and the micro SIM card tray.
3. Lift the top edge of the system board (3), and then remove it.
Reverse this procedure to replace the system board.

POGO connector

Description
POGO connector
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see
b. Back cover (see
c. Display panel (see
d. Battery (see
e. Hall sensor board (see
f. Kickstand hinges (see
g. Solid-state drive (see
h. WLAN module (see
48 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Use care to prevent damaging the ZIF connector and ribbon cable.
Back cover on page
Display panel on page
Battery on page 32)
Hall sensor board on page
Kickstand hinges on page
Solid-state drive on page
WLAN module on page
Kickstand on page 26)
29)
30)
34)
35)
36)
38)
Spare part number
938109-001