Webcam - HP Elite x2 1012 G2 Maintenance And Service Manual

Webcam

Description
Webcam
1p MIPI-RAW 5MP
1p MIPI-RAW VGA
IMPORTANT:
replacement.
Before removing the webcam, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see
b. Back cover (see
c. Display panel (see
d. Battery (see
e. Hall sensor board (see
f. Kickstand hinges (see
g. Solid-state drive (see
h. WLAN module (see
i. WWAN module (see
Remove the webcam:
CAUTION:
Disconnect the ZIF connector and release the webcam cable (1) from the system board, and then lift the
▲
webcam (2) to remove it.
42 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Make special note of each screw and screw lock size and location during removal and
Back cover on page
Display panel on page
Battery on page
Hall sensor board on page
Kickstand hinges on page
Solid-state drive on page
WLAN module on page
WWAN or GPS module (select products only) on page
Use care to prevent damaging the zero-insertion force (ZIF) connector and ribbon cable.
Kickstand on page
29)
30)
32)
34)
35)
36)
38)
Spare part number
900731-002
907895-001
26)
40)