How To Get A Single Parameter From An Id-Net™ Slave Reader - Datalogic MATRIX 210 Programming Manual

PROGRAMMING STRINGS
3.6 HOW TO GET A SINGLE PARAMETER FROM AN ID-NET™ SLAVE
READER
The current value of a single parameter of an ID-NET™ Slave (Multidata) #N can be
obtained through the Master (Multidata) device "encapsulating" the same Host Mode Get
Commands and Get Strings as a Standalone reader, (see par. 3.3), in a special command
with the following format:
Where:

ADDR:

STRING:
ADDR is a character indicating address of the device in an ID-NET™ Master/Slave reading
system layout:
ADDR = <30 > + <Device Address> where:
H
Device Address = 0:
Device Address = 1 to 31:
This means:
ADDR = <30 >:
H
ADDR = <31 > to <4F
H
The following command must be transmitted after sending each get command string:
If the sequence is correct, the device replies with the programming string for the current
value of the parameter:
Parameter Depth = 1
Where:

Character identifying the category of the parameter to get.
CHR1:
 Character identifying the Function in the category.
CHR2:

Character or string indicating the current parameter Value.
DATA:
<ESC> ( <B0 > ADDR STRING ) <ESC>
H
Device Address
Get Command/String To Send (Length: 1 to 252)
Standalone device or Master Multidata ID-NET™ device
Slave Multidata ID-NET™ device
Standalone device or Master Multidata ID-NET™ device
>: Slave Multidata ID-NET™ device
H
<ESC> ( <B0 > ADDR <ESC> I D #) <ESC>
H
<ESC> CHR1 CHR2 DATA <ESC> I A #
3
15