Datalogic MATRIX 210 Programming Manual page 24

3
- 5 -
Set Link Failure String parameter in READING SYSTEM LAYOUT folder:
Type: 2
Length: 0, 32
Value: LINK_FAILURE
The programming string is:
- 6 -
Set OUTPUT 2 Activation Events parameter in DIGITAL I/O folder:
Type: 3
Item List: None, Complete Read, Partial Read, No Read, Acquisition Trigger, Phase
ON, Phase OFF, Run Mode, Host Control Mode, ISO-IEC Symbol Contrast,
ISO-IEC Print Growth, ISO-IEC/AIM DPM Axial Non Uniformity, ISO-IEC/AIM
DPM Unused ECC, ISO-IEC Modulation, ISO-IEC Min Edge Contrast, ISO-
IEC Decodability, ISO-IEC/AIM DPM Fixed Pattern Damage, ISO-IEC/AIM
DPM Grid Non Uniformity, ISO-IEC/AIM DPM Minimum Reflectance, ISO-IEC
Defects, ISO-IEC/AIM DPM Decode, AIM DPM Cell Contrast, AIM DPM Cell
Modulation, AS9132 Dot Size/Cell Fill, AS9132 Dot Center Offset, AS9132
Dot Ovality, AS9132 Quiet Zone, AS9132 Angle Of Distortion, AS9132
Symbol Contrast.
5 6
Value: 2 + 2
The programming string is:
- 7 -
Get current value Link Failure String parameter in READING SYSTEM LAYOUT folder:
Type: 2
Length: 0, 32
Current LINK_FAILURE
Value:
The get string is:
The reader answer is:
20
<ESC> A T LINK_FAILURE <ESC> I A #
(Phase-OFF + Enter In Run Mode) = 96
<ESC> O J 96 <ESC> I A #
<ESC> A T <ESC> I D #
<ESC> A T LINK_FAILURE<ESC> I A #
HOST MODE PROGRAMMING