Front Fork - Gilera Runner Purejet 2007 Workshop Manual

Suspensions
Removal
- Remove the front handlebar cover.
- Remove the rear handlebar cover.
- After removing the transmissions and discon-
necting the electrical terminals, remove the bolt
«A» and the handlebar
- Check all components and replace faulty parts.
N.B.
IF THE HANDLEBAR IS BEING REMOVED TO REMOVE
THE STEERING, TILT THE HANDLEBAR FORWARD TO
AVOIDING DAMAGING THE TRANSMISSIONS.
See also
Front handlebar cover
Rear handlebar cover
Refitting
When refitting, tighten to the prescribed torque and
apply the recommended grease to the threaded
cone.
Recommended products
AGIP GREASE PV2 Grease for control levers
on the engine
White anhydrous-calcium based grease to protect
roller bearings; temperature range between -20 °
C and +120 °C; NLGI 2; ISO-L-XBCIB2
Locking torques (N*m)
Locking torque:
65 to 70 N•m

Front fork

SUSP - 104
Runner Purejet