Gilera Runner Purejet 2007 Workshop Manual page 118

pure jet injection
• ECU INFORMATION
To access the individual functions, the tester must be connected to the vehicle diagnostic outlet and
the ECU must be on.
• To connect the scooter diagnostic tester, raise
the seat
• Remove the battery cover
• Remove the cover from the diagnostics plug
• Connect it to the diagnostic tester wiring
• Connect the power supply cable with battery ter-
minals to the diagnostic tester
• Connect the terminals to the battery respecting
the polarity: RED (+) - BLACK (-)
N.B.
FAILURE TO DO SO MAY PERMANENTLY IMPAIR THE DI-
AGNOSTIC TESTER
N.B.
IF THE VEHICLE BATTERY IS USED, THERE IS NO NEED
TO ATTACH THE BLACK TERMINAL TO THE NEGATIVE
TERMINAL ON THE BATTERY.
• To disconnect the tester, remove the terminals from the battery
• Remove the connector from the diagnostic outlet
• Reapply the protection cap to the diagnostic outlet to prevent dirt from depositing on the contacts
• Refit the battery cover
All the parameters can be displayed by selecting the 4 pages. In case of need, all the parameters can
be stored in the tester by pressing the «TAB» key at the selected time. The parameters are stored as
long as the power of the diagnostic tester is inserted.
INJ PJ - 118
Runner Purejet