Gilera Runner Purejet 2007 Workshop Manual page 200

Chassis
Removing the ignition key-switch when on *lock*
Remove the shield.
- Remove the switch of the key switch.
- Make a hole on the block using a drill as shown
in the figure.
- Insert the wheel cylinder with the key and with the
anchoring tab facing down halfway on the lock
body taking care that the insertion phase of the key
is oriented matching "ON" (the only position that
enables the cylinder to get into the lock body); now
turn the key leftwards to "OFF" and at the same
time press until the cylinder is completely in.
See also
Legshield
Footrest
- Remove the side
- Remove the two screws and loosen the joints
very carefully
See also
Side fairings
CHAS - 200
Runner Purejet