Gilera Runner Purejet 2007 Workshop Manual page 33

Runner Purejet
Grease the ends of the cable.
Transmission adjustment
Set the command cables:
Mix cable: see the following procedure "Mixer Timing".
Gas cable: adjust so there is no play in the sheathes.
Splitter command cable: adjust so there is no play in the gas knob.
All transmissions must be regulated so there is no play in the sheathes.
Mixer timing
Use the transmission register to adjust, with the
gas command released and the position of mixer
lever as shown in the picture.
N.B.
TO VERIFY THE CORRECT TIMING OF THE MIXER IT IS NECESSARY TO REMOVE THE AIR
CONDUIT OF THE TRANSMISSION COVER.
CAUTION
WHEN REMOVING OR WHERE THERE IS NO MORE OIL IN THE TANK, PROCEED WITH THE
BLEEDING ACTIVITIES OF THE MIXER AS FOLLOWS: WITH THE MIXER MOUNTED ON THE
VEHICLE AND WITH THE ENGINE OFF, DISCONNECT THE MIXER TUBE FROM THE CARBU-
RETTOR AND LOOSEN THE BLEED VALVES (SEE ARROW IN PICTURE) UNTIL OIL STARTS TO
FLOW. TIGHTEN THE SCREW, START THE ENGINE AND WAIT FOR OIL TO COME OUT FROM
THE DELIVERY TUBE TO THE CARBURETTOR (ALREADY DISCONNECTED).
Reconnect the delivery tube to the carburettor and secure it with the appropriate clamp.
When doing this step, pour a small amount of the recommended product into the intake or in the blade
holder.
Recommended products
AGIP CITY TEC 2T Mixer oil
synthetic oil for 2-stroke engines: JASO FC, ISO-L-EGD
Maintenance
MAIN - 33