Gilera Runner Purejet 2007 Workshop Manual page 74

Engine
020376Y Adaptor handle
020439Y 17 mm guide
020358Y 37x40-mm adaptor
Refitting the wheel axle bearing
- Heat the half crankcase on the transmission side
using a thermal gun.
- After lubricating its outer strip, insert the bearing
with the special adapter with the aid of a hammer.
- Refit the seeger ring and the oil seal using the 42
x 47 mm adapter and the handle.
Specific tooling
020151Y Air heater
020376Y Adaptor handle
020363Y 20 mm guide
020359Y 42x47-mm adaptor
Refitting the ub cover
• Refit the complete wheel axis.
• Refit the intermediate gear being careful of the
two shim adjustments.
• Apply LOCTITE 510 for surfaces on the hub cov-
er and refit it with the complete pulley shaft.
• Insert the 5 screws and tighten them to the pre-
scribed torque.
N.B.
CLEAN THE CONTACT SURFACES OF THE HUB COVER
AND THE HALF CRANKCASE OF RESIDUE FROM PREVI-
OUS GASKETS BEFORE APPLYING A NEW ONE.
Locking torques (N*m)
Locking torque:
11 to 13 Nm
ENG - 74
Runner Purejet