Gilera Runner Purejet 2007 Workshop Manual page 86

Engine
• Refit the dust cover onto the air injector.
N.B.
NOTE THAN WHEN THE AIR INJECTOR IS REFITTED, THE
CARBON DAM O-RING MUST BE NEW. IF A NEW AIR IN-
JECTOR IS FITTED, THE NEW CARBON DAM RING IS
ALREADY PRESENT. IF THE OLD AIR INJECTOR IS FIT-
TED, THE CARBON DAM REQUIRES REPLACEMENT.
• Fit the spark plug
• Refit the temperature sensor shown in the figure
and tighten to the prescribed torque.
Locking torques (N*m)
Temperature sensor
14 Nm
• Refit the injection head including the fuel injector
and pressure regulator and tighten to the prescri-
bed torque.
Locking torques (N*m)
Injection head fixing screw:
• Use a TORX 20 wrench to refit the air feeding
pipe from the injection head.
See also
air injector circuit
Air Injection
Carbon - dam replacement
ENG - 86
Spark plug:
18 ÷22 Nm 11 ÷
3 ÷ 4 Nm
Runner Purejet