Gilera Runner Purejet 2007 Workshop Manual page 117

Runner Purejet
Specification
PRIORITY 1
PRIORITY 2
PRIORITY 3
menù diagnosis tester
Menu of the diagnostic tester
The specific scooter diagnostic tester is provided with a specific software for the diagnostic of the
PUREJET injection system .
Specific tooling
020460Y Scooter diagnosis and tester
The diagnostic tester is provided with a base setting menu.
To select the various functions, proceed as follows:
1. Press «ESC» and «OK» and keep them pressed while enabling the battery power.
2. The display shows the following menu: ECU DIAGNOSTIC, LINK TO PC, CONTRAST SET, LAN-
GUAGE SET, BUZZER SET, VERSION
3. Select ECU diagnostic
4. Select the software for the PUREJET system
5. Wait until the modules are loaded
6. The diagnostic tester is ready for use. The selected software will stay in memory also for the next
uses
N.B.
IF THE SCOOTER DIAGNOSTIC TESTER IS NOT LOADED WITH THE SYSTEM SOFTWARE, UP-
GRADE WITH A PC, THE PROGRAMMING KIT AND THE SOFTWARE TO LOAD. SET THE
DIAGNOSTIC TESTER TO FUNCTION «LINK TO PC» IN THE MENU.
The main menu of the diagnostic tester has the following functions:
• PARAMETERS
• ERRORS
• PARAMETERS STORED
• ERROR CLEARING
• ACTIVE DIAGNOSTIC
• TPS RESET
• CALIBRATION
AUTO-DIAGNOSTIC
Flashing injection indicator. This signal identifies abnormalities
that could cause serious damage to the engine or stopping of
the vehicle if the vehicle continues to be used.
Steady injection indicator. This denotes faults that impair the
vehicle use since the engine can stop or remain idle.
This priority level denotes faults not reported to the
driver by the injection indicator.
Faults can be perceived by the evident fault of the
engine (i.e. the revolutions do not increase) or by
- Coolant temperature indicator not efficient
- Injection indicator always off or always on
pure jet injection
Desc./Quantity
indication of:
INJ PJ - 117