Gilera Runner Purejet 2007 Workshop Manual page 122

pure jet injection
Specification
AIR INJECTOR
FUEL INJECTOR
HV COIL
FUEL PUMP
TEMPERATURE INDICATOR
CHECK LAMP
ODOMETER
CONSUMPTION GAUGE
When the various diagnostics are enabled, the tester displays its results «ENDED SUCCESSFULLY»
or «FAILED».
The tester results must always be combined with sound or visual checks.
The tester can confirm transmission of the command but cannot check the actual power supply or
efficiency of the circuit under testing.
Resetting the TPS
This function allows combining the throttle body with the ECU.
Calibration
This function makes it possible to insert new calibrations to the ECU with the product developments.
ECU information
The tester displays the following information:
- N. SER. = ECU serial number
- HW REV = Hardware revision N°
- ECU SW = ECU software reference
- CALIBR = Calibration reference
INJ PJ - 122
ACTIVE DIAGNOSTICS
Wait for the sound confirming 5 openings
Wait for the sound confirming 5 openings
Wait for the sound confirming 5 coil magnetic activity (weak
Wait for the sound confirming the pump rotation for approx. 30
The indicator increases to display an average temperature,
then returns to the rest position (to perform with cold engine)
The light is normally on. The diagnostic is confirmed when the
Runner Purejet
Desc./Quantity
signal)
seconds.
light turns off briefly.
Instrument not present on the vehicle
Instrument not present on the vehicle