How To Set The Unit; Control Panel; Main Function - ACME XA-500 User Manual

3. How To Set The Unit

3.1 Control panel

1. Function Display: Used to show the various menus and the selected function;
2. Button:
MENU To select the programming functions
UP To go forward in the selected functions
DOWN To go backward in the selected functions
ENTER To confirm the selected functions
3. DMX IN/OUT: DMX 512 link, use XLR cable to link the unit and DMX controller;
4. POWER IN: Connect to power supply.
5. POWER WITCH: Turn on/off the power;
6. FUSE (T15Amp): Protect the unit from damage of the overcurrent;

3.2 Main Function

To select any of the given functions, press the MENU button up to when the required one is
showing on the display. Select the function by the ENTER button and the display will blink. Use the
DOWN and UP button to change the mode. Once the required mode has been selected, press the
ENTER button to setup, to go back to the functions without any change press the MENU button
again. Hold and press the MENU button about one second or wait for one minute to exit the menu
mode.
The main functions are showing below:
4A