Adjusting Bass And Treble (Tone Control) - Pioneer VSA-AX10 Operating Instructions Manual

Adjusting Bass and Treble (TONE CONTROL)

You can adjust the low (bass) and high (treble) frequencies. The TONE button can also be used to bypass the
tone circuitry.
2
Amplifier
1
BASS/
TONE
TREBLE
DISPLAY VIDEO
DIMMER SELECT
SPEAKER
STATUS
LOUDNESS
A/B
SYSTEM TAPE 2
SETUP MONITOR
1 2
3
• The tone control can be adjusted in a range of ±6 dB.
memo
• The tone control cannot be set on in HOME THX, MIDNIGHT or LOUDNESS modes.
• If the amplifier is in DIRECT mode and you press the TONE button, TONE: BYPASS appears in
the display. You will need to press TONE once more to switch the tone control on, canceling the
(MULTI CH IN or STEREO) DIRECT mode.
3 3
1 Press the TONE button on the
SUB
MAIN SUB
EFFECT/
CH SEL.
INPUT
ATT.
SIGNAL
SELECT
2 Press the BASS/TREBLE button
3 Use the +/– buttons to adjust the low
remote control's AMP SUB screen or
front panel to put the amplifier in
tone adjust mode.
There are two tone modes TONE: ON and TONE:
BYPASS. The first means the tone functions are active
and also lets you adjust these functions. The second
means the tone controls are being bypassed, and thus
have no effect on the sound.
If TONE: BYPASS appears, press the button again to
get TONE: ON, which is the tone adjust mode.
repeatedly to select BASS or
TREBLE.
or high frequency levels.
A few seconds after you finish adjusting the tone the
amplifier will revert to the sound mode it was in at the
beginning of the process.
Basic Operation
55
En