Programming Signals From Other Remote Controls (Learning Mode) - Pioneer VSA-AX10 Operating Instructions Manual

Remote Control of Other Components

Programming Signals from Other Remote Controls (LEARNING Mode)

If preset codes are not available for your component(s), or the available preset codes do not operate correctly,
you can use this procedure to program in signals from the remote control(s) of your other component(s). These
steps can also be used to add further operations to the remote control screens that were successfully set with
the stored settings (see p.60–61).
memo
You can press the BACK button at any time to go back a screen.
Remote Setup
AMP
LCD
COMMANDER
DVD/LD
VCR1 PRESET RECALL
/DVR
2
VCR2
LEARNING
VCR3
MULTI OPERATION
TV
Learning
AMP
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
DVD
AMP
DVD/LD
VCR1
/DVR
VCR2
VCR3
MENU
TV
• You can also program the 5˜∞˜2˜3
memo
and ENTER cursor buttons with the
LEARNING mode.
• The TUNER button cannot be as
signed.
5˜∞˜2˜3 and ENTER cursor buttons
62
En
1
REMOTE
BACK
SETUP
CD
DIRECT FUNCTION
CD-R/
TAPE1
ITEM MEMO
TUNER
VIDEO
KEY LABEL
SAT
TV
CONTROL
BACK REMOTE
SETUP
CD
CD-R/
TAPE1
TUNER
SELECT FUNCTION
VIDEO
SAT
TV
CONTROL
3
BACK REMOTE
SETUP
CD
1 2 3
CD-R/
TAPE1
4 5 6
SEARCH TUNER
MODE
VIDEO
7 8 9
TOP
MENU
SAT
RE-
10 0 C
TV
TURN
CONTROL
STANDBY/ON
ENTER
1 Press the REMOTE SETUP.
2 Press the LEARNING button.
If you want to cancel the REMOTE SETUP mode
SELECT FUNCTION arrows blink on the remote control
display.
3 Press the function button for the
component you want to control.
For example purposes we will use the DVD/LD
function.
4 Choose the command you want to
teach the remote control and press
the corresponding button on the
LCD screen.
For example, choose the 3 (play) button to program
this remote control to play your DVD player.
• The TV POWER, TV INPUT, TV CH +/– and VOL +/–
buttons are only available for learning when pro-
gramming TV CONTROL operations.
• Pressing BACK cancels the process.
5 After you press the command
LEARNING will blink. Point the two
remote controls toward each other.
Press the button on the other
4
remote control corresponding to the
operation you want to program
while LEARNING continues to blink.
After the process is complete and the command has
been learned, OK will appear at the top of the remote
control LCD display.
Repeat steps 4 and 5 to teach the remote control of
the VSA-AX10 all the commands from the other
remote control.