On The Remote Control - Pioneer VSA-AX10 Operating Instructions Manual

5
Amplifier
AMP
BASS/
TONE
ATREBLE
DVD/LD
VCR1
DISPLAY VIDEO
/DVR
DIMMER SELECT
VCR2
SPEAKER
STATUS
A/B
VCR3
SYSTEM
6
TV SETUP
7
System Setup
[ Auto Surround Setup
[1. Input Assign]
[2. Surround Setup]
[3. Expert Setup]
[4. THX Audio Setup]
[Exit]
8
Auto Surround Setup
Speaker System Select
[ Normal Surround
[Go Next]
[Return]
10
Auto Surround Setup
•Connect microphone
•Please be quiet
•Move obstacles away
•If you have a subwoofer
turn power on and
turn volume up
[Start]
[Cancel]
Auto Surround Setup
Please Wait
Caution!!
Test tone is
output loudly.
[Cancel]
Auto Surround Setup
Now Analyzing
•••
Environment Check
Ambient Noise
Microphone
Speaker Level
[Cancel]
Check!!
Front [ YES ]
Center [ YES ]
Surround [ YES ]
SurrBack [ YES
Subwoofer [ YES ]
[OK,Go Next]
[Retry]
[ERR Fix SP.]
[Return to Menu]
5
5 Press AMP then press the SUB button
MAIN SUB REMOTE
SETUP
CD
6 Press the SYSTEM SETUP button and
CD-R/
TAPE1
EFFECT/
CH SEL.
TUNER
VIDEO
INPUT
LOUDNESS
ATT.
SAT
TAPE 2 SIGNAL
TV
MONITOR SELECT
CONTROL
7 The arrow should be pointing at AUTO
8 NORMAL SURROUND should be
]
]
9 Some auto setup instructions will be
10 If you have followed all setup
[OK]
[OK]
[OK]
2]
X
Quick Start Guide Part2

on the remote control.

use the on-screen display (OSD) that
appears on your TV.
SURROUND SETUP, press ENTER.
selected. (Use the 2 3 buttons to
select it if it isn't.) Use the 5∞ buttons
to select GO NEXT and press ENTER.
For Bi-amp settings choose FRONT BI-AMP 5.1 and
follow the directions from step 3 on page 39.
RETURN brings you back to the system setup menu.
listed, make sure to follow them.
Make sure you have: hooked up the microphone and
moved obstacles to the speakers out of the way. If you
have a subwoofer make sure it is turned on and has the
volume turned up.
WARNING: The test tones are very loud!! Make sure
there are no infants or small children in the room and
that no one who will be scared, upset or injured by loud
noise is present. You yourself may want to wear ear-
plugs. It is possible to lower the volume of test tones,
but this could result in incorrect speaker settings.
instructions and warnings above make
sure that the arrow is pointed to
START and press ENTER. Be prepared
for loud test tones.
Try to be as quiet as possible after hitting ENTER. The
test tones may take up to 30 seconds.
The volume automatically increases to 0 dB, then the
system will output some test tones and establish
ambient noise levels, the microphone status, and what
speakers you hooked up.
15
En