Switching A/B Speaker System - Pioneer VSA-AX10 Operating Instructions Manual

Using Other Functions

Switching A/B Speaker System

This unit has three types of speaker systems A, B, A&B. This switch allows you to select the speaker system
you will use.
Amplifier
BASS/
TONE
TREBLE
DISPLAY VIDEO
DIMMER SELECT
SPEAKER
STATUS
1
A/B
SYSTEM
SETUP
1
• Depending on the settings in "SPEAKER SYSTEMS" and the MULTI CH IN SELECT, output from the
memo
surround back pre out terminals may change.
• When using headphones the speakers are switched off.
• Please use speakers with a nominal impedance rated 6 -16 .
68
En
MAIN SUB
EFFECT/
CH SEL.
INPUT
LOUDNESS
ATT.
TAPE 2 SIGNAL
MONITOR SELECT
A(SP3A):
B(SP3B):
A&B(SP3AB):
OFF(SP3 ):
1 Use the SPEAKER A/B button on the
remote control's SUB screen (or SP
SYSTEM A/B on the front panel) to
cycle through the different speaker
systems.
The button cycles through the speaker systems as
follows: A]B]A&B]off.
In what way the sound will be output depends on
the selections you made in "SPEAKER SYSTEMS"
(p.38) and you choices here. See the explanations
for a guide to how the sound will be output when
you have chosen NORMAL SURROUND (see p.38-
39).
Sound is output from speaker system A and the same
signal is output from the pre out terminals. (Subwoofer
output depends on the settings in SPEAKER SYSTEMS
and the source type.)
Sound is output from the two speakers in speaker
system B. Multichannel sources will be downmixed to
these two speakers and the same signal is output from
the FRONT pre outs.
Sound is output from speaker system A's FRONT
speakers and the B speakers. The main channels will
be downmixed to the FRONT speakers. (Subwoofer
output depends on the settings in SPEAKER SYSTEMS
and the source type.) If you have set the FRONT
speakers to "SMALL" the low frequencies of all the
channels are output from the subwoofer. The same
sound is output from the B speakers and the FRONT
pre out terminals.
No sound is output from the speakers. Depending on
the input signal and settings in "SPEAKER SYSTEMS"
sound may be output from the subwoofer. The same
sound is output from the pre out terminals as when
selecting speaker system A (above).