Check The Auto Settings; Speaker Settings - Pioneer VSA-AX10 Operating Instructions Manual

Check the Auto Settings

If you want to check what settings have been input for your surround sound parameters you can do it following
the steps below.
1
Amplifier
AMP
BASS/
TONE
ATREBLE
DVD/LD
VCR1
DISPLAY VIDEO
/DVR
DIMMER SELECT
VCR2
SPEAKER
STATUS
A/B
VCR3
SYSTEM
3
TV SETUP
5
2.Surround Setup
[ Check ]
[ 1.Speaker Systems ]
[ 2.Channel Delay ]
[ 3.Channel Level ]
[ 4.Acoustic Cal EQ ]
[Return]
1 Switch on the amplifier and your TV.
2
MAIN SUB REMOTE
SETUP
CD
CD-R/
TAPE1
2 Press the SUB button on the remote
EFFECT/
CH SEL.
TUNER
VIDEO
INPUT
LOUDNESS
ATT.
SAT
TAPE 2
SIGNAL
TV
MONITOR SELECT
CONTROL
3 Press the SYSTEM SETUP button and
4 Use the 5∞ buttons to select
5 CHECK should be selected, press
6 The first menu in which you can check
7 When you want to check the next
8 Continue to move through the menus
9 To exit the this mode select RETURN
Setting Up for Surround Sound
Make sure your TV is set to this amplifier as you will use
the on-screen displays on your TV to follow these
instructions.
control's AMPLIFIER screen.
use the on-screen display (OSD) that
appears on your TV.
The SYSTEM SETUP menu appears on the OSD.
SURROUND SETUP and press ENTER.
ENTER.
your settings will appear. This is the

speaker settings.

Navigate this menu with the 2 3 buttons.
settings select NEXT with the 5∞
buttons and press ENTER.
The order of the settings menus is: Speaker Systems;
Channel Delay; Channel Level; Acoustic Calibration EQ.
If you want to leave the settings check select RETURN
with the 5∞ buttons and press ENTER.
using the 5∞ buttons and pressing
ENTER until you are done checking the
settings.
with the 5∞ buttons and press ENTER.
You will return to the SURROUND SETUP menu. Then
select EXIT and press ENTER to exit the setup process.
45
En