Attaching The Bass Boost Remote Control; Example Of Installation On The Floor Mat Or Chassis - Pioneer GM-D8701 Owner's Manual

Installation
Attaching the Bass boost
remote control
Attach with tapping screws (3 mm × 10 mm
(1/8 in. × 3/8 in.)) at an easily accessible loca-
tion such as under the dashboard.
Tapping screws (3 mm × 10 mm (1/8 in. × 3/
8 in.))
Example of installation on
the floor mat or chassis
1 Place the amplifier in the desired instal-
lation location.
Insert the supplied tapping screws (4 mm ×
18 mm (5/32 in. × 3/4 in.)) into the screw holes
and push on the screws with a screwdriver so
they make an imprint where the installation
holes are to be located.
2 Drill 2.5 mm (3/32 in.) diameter holes at
the imprints either on the carpet or directly
on the chassis.
3 Install the amplifier with the use of
supplied tapping screws (4 mm × 18 mm
(5/32 in. × 3/4 in.)).
3
4
1 Tapping-screws (4 mm × 18 mm (5/32 in. ×
3/4 in.))
2 Drill a 2.5 mm (3/32 in.) diameter hole.
3 Floor mat or chassis
4 Hole-to-hole distance: 229.5 mm (9-1/32 in.)
(GM-D8701 and GM-DX871) / 279.5 mm
(11 in.) (GM-D9701 and GM-DX971)
5 Hole-to-hole distance: 191.5 mm
(7-17/32 in.)
En
1
2
5