Setting Up The Direct Function - Pioneer VSA-AX10 Operating Instructions Manual

Setting up the DIRECT FUNCTION

The direct function will not be necessary for most users. It is designed in case you have an external video
source connected to your TV (a video source that is not going through the VSA-AX10). For this explanation we'll
call this the "external video deck." You'd like to control external video deck with this unit's remote control so
you've assigned it a function button (for example purposes, the VCR 2 button). Yet, if you put the amplifier in
VCR 2 mode you'll get no picture on your TV because the external video deck signal is not going through the
VSA-AX10. To get around this problem you set the DIRECT FUNCTION for VCR 2 to OFF. Now when you press
VCR 2 function button you can control the external video deck with the remote but the amplifier does not go into
VCR 2 mode.
Remote Setup
AMP
LCD
COMMANDER
DVD/LD
VCR1 PRESET RECALL
/DVR
VCR2
LEARNING
VCR3
MULTI OPERATION
TV
Direct Function
AMP
ON
DVD/LD
VCR1
ON
/DVR
ON
VCR2
ON
VCR3
ON
TV
3
1
2
1 Press the REMOTE SETUP.
BACK REMOTE
2 Press the DIRECT FUNCTION button.
SETUP
CD
DIRECT FUNCTION
CD-R/
TAPE1
3 Choose the DIRECT FUNCTION
ITEM MEMO
TUNER
VIDEO
KEY LABEL
SAT
TV
CONTROL
4
BACK REMOTE
SETUP
ON
CD
CD-R/
ON 4 To leave the Direct Function mode
TAPE1
ON
TUNER
ON
VIDEO
ON
SAT
TV
CONTROL
3
Remote Control of Other Components
setting of each MULTI CONTROL
button by pressing on the ON/OFF
button.
A triangular arrow points from the ON/OFF button
towards a small nub next to the function names (DVD/
LD, CD, etc.) that can be turned ON/OFF. This nub will
disappear if that DIRECT FUNCTION is turned OFF.
Subsequently the nub will not appear on any remote
control screen if the DIRECT FUNCTION is OFF.
press the BACK button.
The default setting for all DIRECT FUNCTIONs is
memo
ON.
65
En