No.
Part name
⑤
Application
1.Detachment
control
1) Perform 1 of ① to remove the electrical parts
P.C. board
box cover.
2) Take off the screws A and B then remove the
3) Remove the CN1(RED) connector from the P.C. board.
NOTE
First unlock the housing and then remove the
connectors.
4) Unlock the locking card edge spacers (3 positions)
in the electrical parts box to remove the P.C. board.
2.Attachment
1) Mount the application control P.C. board in the
2) Be sure to wire in the electrical parts box as before.
NOTE 1
Check if there is no missing or contact failure
of the connectors.
NOTE 2
Be sure to wire as before.
3) Return terminal block assembly to the original
4) Attach the electrical parts box cover as before.
Procedure
terminal block assembly.
electrical parts box as before.
position without pinching wires.
Confirm to hook the claw of terminal block assembly
on the right side.
Then fix screw A and B.
FAN control P.C. board
CN505(RED)
Screw B
CN1
Screw A
CN1
Control circuit board
Application control
P.C. board
- 85 -
Remarks
Card edge spacer
(3 positions)
Cord clamp
Fixing claw for terminal block
Terminal block assembly