Toshiba MMD-AP0726HP-UL Service Manual page 41

To change all the indoor unit addresses using an arbitrary wired remote control.
(The method is available when the addresses have already been set automatically.)
(When communication wirings of 2 or more refrigerant lines are interconnected for central control)
NOTE
You can change the addresses of indoor units in each refrigerant line using an arbitrary wired remote control.
* Enter the address check / change mode and change the addresses.
If no number appears on UNIT No., no outdoor unit exists on the line. Push button and select another line
2
following step .
(Execute it while the units are stopped.)
1
Push and hold the TIME
At first, the line 1 and CODE No.
UNIT LOUVER
2
Push button (left side of the button) and
address.
3 SET
Push the button.
• The address of one of the indoor units connected to the selected refrigerant line is indicated on the LCD display and
the fan 4of the unit are activated.
At first, the current indoor unit address is displayed in SET DATA.
(No system address is indicated.)
TEMP.
TIMER SET
TIME
1
FILTER
RESET TEST SET CL
3
Cancels the line selection
/ buttons at the same time for more than 4 seconds.
AC AC AC AC AC
(Address Change) are indicated on the LCD display.
ON / OFF
FAN MODE
SAVE VENT
SWING/FIX UNIT LOUVER
2
buttons repeatedly to select a system
SWING/FIX
- 41 -