Toshiba MMD-AP0726HP-UL Service Manual page 35

Manual address setting using the remote control
Procedure when setting indoor units' addresses first under the condition that indoor wiring has been completed
and outdoor wiring has not been started (manual setting using the remote control)
Wiring example of 2 refrigerant lines
Refrigerant line 1
Outdoor
Indoor unit 1
Remote
control
Line (system) address
Indoor unit address
Group address
In the example above, disconnect the remote control connections between the indoor units
and connect a wired remote control to the target unit directly before address setting.
Pair the indoor unit to set and the remote control one-to-one.
Turn on the power.
1
Push and hold the
LCD starts flashing.
unit
Indoor unit 2
1 1
1 2
1 2
Header unit Follower unit
SET DATA
TEMP.
2, 5, 8
11
FILTER
RESET TEST
1
CL
SET
, and buttons at the same time for more than 4 seconds.
Refrigerant line 2
Outdoor
unit
Indoor unit 3 Indoor unit 1
1
3
2
Follower unit Follower unit
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
4, 7, 1 0
SET CL SWING/FIX UNIT LOUVER
- 35 -
Indoor unit 2
2 2
1 2
2 2
Follower unit
Code No.
3, 6, 9