Installation Overview; Completing The Mounting Bracket Assembly - Motorola PMP 320 Hardware Installation

PMP 320 Hardware Installation

Installation Overview

■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■
After finding the best installation location on the building, perform the following procedure
to install the CSM.
Procedure 5-2
1
2
3
4

Completing the mounting bracket assembly

Perform the following procedure to complete the mounting bracket assembly.
Figure 6-3
Procedure 5-3
1
2
3
4
5
PMP320HDW2v1
■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■
Installing the CSM
Complete the mounting bracket assembly; leave the screws on the bracket
arm slightly loose. If the screws are too tight, the vertical and horizontal tilt
of the CSM cannot be adjusted later.
NOTE
If fastening the CSM to a pole, add the pole clamp to the assembly.
Otherwise, set the pole clamp aside.
Perform one of the following:
1.
If attaching the CSM to the side of a building, attach the CSM to the
building using the wall bracket of the bracket assembly.
2.
Mount the CSM to a pole using the wall bracket and pole clamp of the
bracket assembly.
Adjust the vertical and horizontal tilt of the CSM so that it can obtain the
best signal.
Fully tighten the bracket assembly into the desired position.
to reference the brackets and the assembly of the brackets.
Mounting bracket assembly
Attach one end of the bracket arm to the arch on this wall bracket.
Insert a 5/16×1½ hex bolt into the arch of the wall bracket that was attached
to the CSM in step
inside the bolt jam of the arch.
Guide the rest of the bolt through the arch of the wall bracket.
Slide a tooth lock washer on the end of the hex bolt.
Align the hole on one tab of the bracket arm with the end of the bolt.
■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■
1. Ensure that the head of the medium hex bolt rests
Preliminary
Installation Overview
■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■
■ ■ ■ ■ ■
■
■
Refer to
Continued
5-7
JUL 2010