Connecting The Antenna Cables To The Unit; Figure 6-5: Connectorized Csm Antenna Cable Connector - Motorola PMP 320 Hardware Installation

PMP 320 Hardware Installation

Connecting the Antenna Cables to the Unit

■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■
Use the following procedure to connect the antenna cables to the unit. Depending upon
the type of antenna used, either two omni antennas, or one diagonal polarized antenna, the
connectors from the installed antennas must be connected to the Connectorized CSM unit
N-type connectors.
Ensure that the cable length between the CSM and the antenna connectors is 18 inches (1 ft
and 6 in).
Refer to the Chapter titled Installing Antennas for additional information regarding antenna
installation procedures.
Figure 6-5
Procedure 6-6
using an Omni Antenna
1
2
3
PMP320HDW2v1
■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■
Connectorized CSM antenna cable connector location
Connecting the Antenna Cables to the Connectorized CSM when
Verify that the length between the CSM and the Omni antennas is 18 inches
apart (1 ft and 6 in). Refer to
the CSM.
Using a 50 ohm low loss cable with an N-type connector, connect the end of
the cable from the Omni antenna connector to the CSM N-type connector.
Repeat step 1 for the second Omni antenna.
■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■
Figure 6-5
Preliminary
Connecting the Antenna Cables to the Unit
■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■
G1_Ccsmantennaconnid.eps
for cable connection location on
■ ■ ■ ■ ■ ■
■
■
6-11
JUL 2010