Motorola PMP 320 Hardware Installation page 69

Installing the CMM4
Figure 3-4
Prizm and Wireless Manager treat the EtherWAN Switch in a CMM4 as a generic switch. For
Prizm or Wireless Manager to correctly associate each EtherWAN Switch with its CMM4:
•
before you install the CMM4, read and note the MAC address of both the CMM4 controller
and EtherWAN switch from the physical units.
•
after you discover a CMM4 and its switch, use these MAC addresses for moving the
switch to the place in your Prizm or Wireless Manager network view where the CMM4
was discovered.
•
always maintain a record that associates these two MAC addresses.
CAUTION
Perform the following procedure to install the CMM4.
PMP320HDW2v1
CMM4 unit opened showing connection details
Cabling Diagram on
Inside of Front Door
When an EMS discovers an EtherWAN switch in your network, it can't tell which CMM4
the switch is associated with, nor can it tell CMM4 EtherWAN switches from any other
EtherWAN switches you may have in your network. The pair of MAC addresses you
record directly from the CMM4 and its EtherWAN switch are the only means for you to
establish the logical connection.
Preliminary
Chapter 3: CMM4 Hardware Installation
Cable Gland
Cable Housings
3-39
JUL 2010